Built by Hobbyist for Hobbyist!
It is currently Mon Sep 16, 2019 9:14 am

All times are UTC - 5 hours

Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Oct 29, 2017 10:16 pm 

Joined: Mon Jul 25, 2016 9:08 am
Posts: 8
So, I'm no super hobbyist so this passage is a bit vague to me. Figured I'd better double check before I went ahead.
I'm assuming I need to close the power circuit on the RS-UV3 since the RS-UVPA has it's own switch otherwise I'd have to switch them both on.
Can I just use a 2.54mm spacing header and jumper piece here? I'd just use a short wire as directed except I don't actually have any that small dia. I'll have to shop for something either way and the header seems a bit cleaner in the end. Might have to clip it short a bit to fit in-between the 2 boards.

Those light pipes are pretty fiddly when you try to get the holes in the case end to match up.

PostPosted: Mon Oct 30, 2017 5:22 am 

Joined: Mon Jul 23, 2012 6:25 am
Posts: 1143
Yes, a 2 pin 0.1" (2.54mm) header with a shorting clip is an excellent way of making sure the RS-UV3 is powered. The next production run will have these already installed. My advise on the light pipes is 'don't try too hard'. You can press them firmly into the PCB and the will stay in place unless something bumps into them. So push them into the holed and then treat the boards very gently until you can slide them into place.

I know it's not a huge help but once you get them in you can forget about them. In new designs we'll be avoiding these as well.


Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group